Flowserve XLC Series Bedienungsanleitung PDF herunterladen (Seite 2)

1 Equipment Check

1.1 Follow plant safety regulations prior to equipment disassembly:

 •Lockoutmotor.      

•Weardesignatedpersonalsafetyequipment.   

•ConsultplantMSDSlesforhazardousmaterialregulations.

1.2 AttherstinstallationofanXLCbearingdisassemblefanshaftassembly

inaccordancewithequipmentmanufacturer’sinstructionsandremove

upper bearing arrangement. Retain upper bearing mounting bolts and/or

nutsforXLCbearinginstallation.

1.3 Checkbearingassemblydrawingforanymodicationsrequiredtothe

equipmentbeforeinstallationandactaccordingly.

1.4 CheckshaftOD,distancetotherstobstruction,andbearinghousing

boltingtoensuretheyaredimensionallywithinthetolerancesshownon

thebearingassemblydrawing.Checkboltlengthtoensureadequate

threadengagementfortheactualbearinghousing.

1.5 Thoroughlyinspectandcleanthemountingplateandshaftorshaft

sleeve.Inspectforcorrosionoranydefects.Removeallburrs,nicksor

scratches,andsharpedgesfromtheshaftand/orsleeveinthebearing

area.Removesharpedgesfromkeywaysandthreads.Replaceworn

shaftorshaftsleeve.

1.6 CheckequipmentrequirementsasdescribedinFigure1.Anyreading

greaterthanwhatisallowedmustbebroughtwithinspecications.

Mounting Requirements Figure 1

102mm(4.0inch)

torstobstruction

Sleeveorshaftnishtobe

0.4 mmm (16 minch)R

or better

Faceofmountingplatetobesquare

totheaxisoftheshaftwithin

2.5°ofperpendicular

•Maximumshaftrunoutatmountingplaste=0.05mm(0.002inch)FIM

•Maximumdynamicshaftdeectionatmountingplate=0.05mm(0.002inch)FIM

ShaftorsleeveOD

+0.000mm(+0.000inch)

-0.050mm(-0.002inch)

1 2 3 4 5 6 7 8

Keine Kommentare

Flowserve XLC Series Bedienungsanleitung Seite 2