Flowserve 75 10-23 Series Motor Module Bedienungsanleitung PDF herunterladen (Seite 2)

Flow Control

Worcester Actuation Systems

2 Series 75 10-23 Motor Module FCD

WCAIM2066-00

When the motor module is located with “output-slow” clos-

est to center shaft, connect actuator wires as shown except

interchange grey and yellow motor leads at the motor capacitor

(12 and 22 size actuators). If capacitor has metal retaining ring,

insulating ﬁ ber washer must be used.

For 20 75 actuators, 100% duty cycle, the motor module is

mounted to the actuator with the “output-slow” closest to the

center shaft. As before, interchange the grey and yellow leads

from the motor at the capacitor. If capacitor has metal retaining

ring, insulating ﬁ ber washer must be used.

SPECIAL NOTE

DC Actuators: Observe the following when installing DC motor

modules:

When the motor module is located with “output-fast” closest to

the center shaft, connect actuator wires as shown (10 and 20

size actuators). For 23 size only, wires are connected as shown,

except that motor module is located with “output-slow” closest

to center shaft.

When the motor module is located with “output-slow” closest

to the center shaft, connect actuator wires as shown, except

interchange the wiring location of the motor’s red and black

leads. The black wire(s) are connected to terminal 1, while the

red wire(s) are crimped with the blue wires (12 and 22 size

actuators).

Alternatively, the supply voltage polarity may be reversed to

accomplish the same thing. That is, if the motor module is

located with “output-slow” closest to the center shaft, simply

reverse supply voltage polarity for proper operation.

Never do

both!

If in special circumstances DC motor is mounted on top of gear-

box from AC motor module, the bearing from gearbox has to be

removed to eliminate bindings. (DC motor has two bearings in

the housing already.)

1 2 3 4

Keine Kommentare

Flowserve 75 10-23 Series Motor Module Bedienungsanleitung Seite 2