WCAIM2037 DataFlo Digital Electronic Positioner DFP17 Installation, Operation and Maintenance Instructions 25
Figure 9
The following screen appears when the ICP program is first started:
The following screen appears after the Positioner Default Data is Loaded: (Some values may vary)
Flow Control
Worcester Actuation Systems
Security Code:
Unit Address:
Output Current Rng (mA):
Setpoint Direction
Split Range Start (%):
Split Range End (%):
Ramp Open Time (sec):
Ramp Close Time (sec):
Setpoint Function:
Dead Band:
Loss of Sig Position:
Loss fo Sig Time:
Power-on Position:
Power-on Time:
Lower Limit (%):
Upper Limit (%):
Tight Shutoff OK?:
Full Open OK?:
Brake ON Time (sec):
Run Cycles:
Deviation Alarm (sec):
Over-travel Alarm (%):
Under-travel Alarm (%):
Input:
PC Cmd:
Output:
Shaft Pos:
DB Run:
Over Under Dev Therm
Open Time:
Close Time:
Cycle Time:
F2 - Load File
F3 - Save File
F4 - Toggle Control
F9 - Free Curve Edit
F10 - Text Area Edit
F12 - Change Position
↔ - Dec/Inc Position
Alt-x - Exit Program
Comm Link:
Status
Alarms
Calibration Data
Ver. x.xx
Security Code: XXXX
Unit Address: 1
Output Current Rng (mA): 4-20
Setpoint Direction: RISE
Split Range Start (%): 0
Split Range End (%): 100
Ramp Open Time (sec): 0
Ramp Close Time (sec): 0
Setpoint Function: LINEAR
Dead Band: 0.5
Loss of Sig Position: 0
Loss fo Sig Time: 0
Power-on Position: 0
Power-on Time: 0
Lower Limit (%): 0
Upper Limit (%): 100
Tight Shutoff OK?: NO
Full Open OK?: NO
Brake ON Time (sec): 0.25
Run Cycles: 0
Deviation Alarm (sec): 35
Over-travel Alarm (%): 100
Under-travel Alarm (%): 0
Input: 45.0%
PC Cmd: 50.0%
Output: 12.0 mA
Shaft Pos: 50.1%
DB Run: 0.5%
Over Under Dev Therm
Open Time: 25s
Close Time: 25s
Cycle Time: 50s
F2 - Load File
F3 - Save File
F4 - Toggle Control
F9 - Free Curve Edit
F10 - Text Area Edit
F12 - Change Position
↔ - Dec/Inc Position
Alt-x - Exit Program
Comm Link: CONNECTED
Status
Alarms
Calibration Data
Ver. x.xx
Kommentare zu diesen Handbüchern