Flowserve SLM-6000 Bedienungsanleitung

Experience In MotionInstallation InstructionsDurametallic® SLM-6000, SLM-6100Self contained cartridge medium duty slurry seal

10Remove Centering/Setting Plates Prior to Operation Figure 15Centering/Setting plate shown in the stored position for equipment operation

7.2.4 Supply tank “Buffer” uid level must be maintained at all times when equipment is pressurized and in operation. Fresh buffer uid shoul

10 Repair This product is a precision sealing device. The design and dimension tolerances are critical to seal performance. Only parts supplied by Flo

21 Cartridge Installation InstructionsThe following instruction manual is designed to simplify the installation of a typical SLM-6000 or SLM-6100 slu

32.2 The saddle ts of the bearing assembly should not be worn.2.3 The axial end oat of the pump shaft must not exceed 0.25 mm (0.010"). See F

4 3.1 Ensure that the bearing assembly is mounted correctly (central and square) to the pump pedestal and securely fastened.3.2 Ensure that all t

53.8 If the seal is tted with quench ports, orient the ports as illustrated in Figure 6.Quench InletQuench Port Orientation Figu

4.4 If the seal is mounted directly on the shaft, rather than on the equipment sleeve, install the impeller spacer sleeve (possibly modied).4.5 Ins

7Cartridge in Place (Wet Side) Figure 10Slide Cartridge onto Shaft

8Check Seal Chamber Concentricity Figure 12Check Seal Chamber Face Runout

9Cartridge in Place (Dry Side) Figure 146 Completing Installation6.1 Evenly tighten the Socket He