Flowserve SLM-6200 Bedienungsanleitung PDF herunterladen (Seite 3)

2.4 Shaft radial runout should be less than 0.0005 mm per mm (0.0005 inch

per inch) of shaft/sleeve diameter. See Figure 3. Turn the shaft through

360° and observe the range of indicator movement.

Check Axial Shaft Travel Figure 2

0.25 mm (0.010 inch) Maximum

Acceptable Axial Movement

Maximum Acceptable Radial

Runout 0.0005 mm per mm

(0.0005 inch per inch) of shaft

diameter

Check Radial Shaft Runout Figure 3

2 Recommendations

To ensure that your SLM-6200 Mechanical Seal will provide you with the longest possible

life, we recommend the following:

2.1 New radial and thrust bearings be installed in the pump.

2.2 The saddle ts of the bearing assembly should not be worn.

2.3 The axial end oat of the pump shaft must not exceed 0.25 mm (0.010 inch). See

Figure 2.

2.5 The shaft should deect no more than 0.30 mm (0.012 inch) at the seal chamber

face. See Figure 4.

Check Radial Shaft Deection Figure 4

Shaft should Deect no more than

0.30 mm (0.012 inch)

1 2 3 4 5 6 7 8 ... 11 12

Keine Kommentare

Flowserve SLM-6200 Bedienungsanleitung Seite 3