Flowserve Bearing Gard Bedienungsanleitung PDF herunterladen

Installation, Operation

and Maintenance Instructions

Bearing Gard

Section 1 - Description of Use

The Bearing Gard is a permanent, non-wearing bearing

protection device used to replace lip seals and simple

labyrinth seals in bearing housings for pumps, motors,

gearboxes and other pieces of rotating equipment. It's

main purpose is to retain lubrication in the bearing

housing and prevent the ingress of contamination as this

can lead to premature failure of the lubrication and

bearings.

Section 2 - Hazzard Summary

To ensure safe and reliable operation of the Bearing

Gard follow all installation, operation, and maintenance

instructions. Failure to comply with these instructions

may result in frictional heating of the Bearing Gard

components and will result in loss in performance.

Section 3 - Preparations for Installation

3.1 Remove the oil seal from the housing.

3.2 Inspect for and remove sharp edges from the

housing bore, keyways, and shaft steps where

Bearing Gard O-rings must pass.

3.3 Thoroughly clean both the shaft and housing bore.

3.4 Ensure Bearing Gard shaft O-ring position is

located on an area of the shaft free from scratches,

nicks, or dings.

3.5 Shaft and housing surface nish must be

0.8 micrometer (32

min) or better.

3.6 Concentricity of the housing bore to the shaft must

to be maintained within 0.127 mm (0.005 inch) TIR.

Oil outlet

Contaminant

outlet

Rotor

Housing

Stator

Shaft

Bearing Gard

cross section.

Features vary

by design.

Oil outlet

Contaminant outlet

Top view

Bottom view

Maximum

oil level

To ﬁnd your local Flowserve representative

and ﬁnd out more about Flowserve Corporation,

visit www.ﬂowserve.com

1 2

Inhaltsverzeichnis

Seite 1 - Bearing Gard

Installation, Operation and Maintenance InstructionsBearing GardTM Section 1 - Description of UseThe Bearing Gard is a permanent, non-wearing beari

Seite 2 - Section 6 - Maintenance

Section 4 - Installation4.1 Do not disassemble the Bearing Gard. It is designed to be installed as a unit.4.2 Lightly lubricate O-rings, sha

Kommentare zu diesen Handbüchern

Keine Kommentare

Flowserve Bearing Gard Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Hardware Flowserve Bearing Gard herunter. Flowserve Bearing Gard User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Hardware Flowserve Bearing Gard