Flowserve PSS III Durametallic Bedienungsanleitung

RepairInstructionsDurametallic® PSS IIISplit SealExperience In Motion

108 Gland Gasket Installation8.1 Assembletheglandhalves.Tighten the cap screws until the gland joints are metal to metal.8.2 Wipetheglandg

118.6 Aftercutting,iftheoverlappingglandgasketendsarestucktothe gland, use the sharp blade togentlyliftthemtobreakthebond.9 Se

129.5 Pushtheendintotheadhesiveandcheckthegasketextensionwiththeheightgauge.Holditin place for 10 seconds. See Figure 25.9.6

1311 Spring Holder Installation11.1 Place the coil springs in the springholes.SeeFigure28.11.2 Set the gland half face down on the table and

14Figure 3313.5 Repeat this procedure for the other seal drive half.13.6 Lubricatetheexposedsurfacesofeachsleevegasketincludingtheendsan

1514.4 Push the stationary face radially into the gland and then down as thelockpinslipsintothelockpinslot.Thestationaryfaceshouldsit

TOREORDERREFERTOB/M#F.O.To find your local Flowserve representativeand find out more about Flowserve Corporation, visit www.flowserve.comFIS176eng RE

2Seal DriveStationaryFaceSetScrewRotatingFaceGlandCenteringDevicePSS III seal referenceGlandGasketSplit Joint gasketCoil SpringSleeve GasketSplit Join

3These instructions are to be used in conjunction with the PSS III Repair Kit. The Repair Kit contains replacement seal faces, secondary seals, Loctit

41 Disassemble and Clean 1.1 Remove the cap screws from the seal drive and gland.1.2 Remove the rotating and stationary face halves by lifting the

5Note: Forallstandardsizeseals(.125inchincrements),therotatingfacegasket,seatgasketandsleevegasketarecuttotheproperlengthatth

64 Sleeve Gasket and Rotating Face Gasket InstallationFigure6Figure7Figure8Figure 54.1 Wipethesleevegasketgrooveclean with alcohol.Caution:

7Figure9Figure 10since too much adhesive impedes gasketexibilityandcanleadtoexcessiveleakage.4.6 Pushtheendintotheadhesiveandcheckt

81.02 - 1.52 mm(0.040 - 0.060 inch)5.3 Put one dot of adhesive near the outer corner. See Figure 11.5.4 Put one dot of adhesive near the inner cor

96 Setting Device Installation6.1 Placethesettingdeviceoverthelocating hole and secure with the cap screw. See Figure 14.6.2 Repeatthisproc