Flowserve OR 42 Bedienungsanleitung PDF herunterladen (Seite 11)

Fault Finding

Fault Possible reason Remedy

No lighting up of LEDs Mains fuse defective Replace mains fuse

Lamp “Malfuncion” on Basic turbidity of fluid too high Refer to “Basic turbidity too high” in this table

Glass cylinder highly contaminated Clean or replace glass cylinder

Glass cylinder scratched (solids in condensate) Replace glass cylinder. Install ORG 12/ORG 22

acc. to mounting suggestion Fig. 5

Glow lamp in light emitter defective Replace glow lamp

Cable leading to light emitter defective Check cable

Calibration of zero point Cable leading to light receiver defective Measuring of lamp voltage < 12 V only possible

(0 %) not possible if lamp intact

Glass cylinder highly contaminated Clean or replace glass cylinder

Glass cylinder scratched (solids in condensate) Replace glass cylinder. Install ORG 12/ORG 22

acc. to mounting suggestion Fig. 5

Glass cylinder covered with condensation Check gaskets of terminal boxes and glass cylinder,

O-rings of light emitter and light receiver

Drying cartridge assumed pink colour? Replace drying cartridge

Extremely eccentric position of glow lamp filament Insert glow lamp with central filament position

Basic turbidity of fluid too high Add indicated value of 100% calibration to turbidity

standard value

No indication of measured Cable leading to light receiver defective Check cable

value

Basic turbidity too high Presence of gas or steam bubbles (flashing) Throttle outlet (indication must drop)

Basic turbidity specific of fluid To measure basic turbidity: Repeat calibration of 0 %

and 100% with distilled water

Measured value rises If ingress of foreign matter can be excluded, Operate cleaning device more frequently

continually 1 ppm/day growing contamination of glass cylinder

Glow lamp often defective Heat accumulation in light emitter since fluid Remove drying cartridge and install vent nipple

temperature > 60°C and drying cartridge mounted

If faults occur that are not listed above,

please contact our subsidiary or agency

in your country.

1 2 ... 6 7 8 9 10 11 12

Keine Kommentare

Flowserve OR 42 Bedienungsanleitung Seite 11