Flowserve P-50 Durametallic Bedienungsanleitung

Installation InstructionsDurametallic® P-50 Experience In MotionA cartridge mounted, flexible stator pusher seal design for generalservice applications

104.3.2 Coat all sleeve O-rings with silicone lubricant and install them onto the sleeve. See Figure 11. Note: Earlier versions of the P-50 utilized

114.3.7 Coat the stator O-ring with silicone lubricant and install it into the gland ring groove.4.3.8 Place the gland ring over the stator being

TO REORDER REFER TOB/M #F.O.FIS112eng REV 10/13 Printed in USAflowserve.comTo find your local Flowserve representativeand find out more about Flowserve C

2Congratulations You have just purchased a reliable, long-life product manufactured by the leading manufacturer of sealing systems in the world. With

3Seal Chamber Requirements Figure 11.5 Check equipment dimensions to ensure that they are within the dimensions shown in Figures 1 and 2.

4 1.000 1.625 2.000 1.50 1.750 1.88 2.00 3.69 - 3.75 1.19 2.75 2.88 1.125 1.750 2.125 1.62 1.875 1.88 2.00 3.81 - 3.88 1.19 2.88 3.00 1.250 1.875 2.

52 P-50 InstallationNote: No seal setting measurements are needed to install the P-50 seal. Instructions are for vertically split case end-suction AN

62.5 Position the P-50 with the gland tight against the seal chamber face. Turn the gland so that the ush tap is as close to the 12:00 o'clock

73 Operational Recommendations3.1 Install an adequate seal ush system. The P-50 requires a clean cool environment for maximum seal life. With a

84.1 Repair Procedures4.1.1 These instructions are to be used in conjunction with the P-50 Repair Kit. The Repair Kit contains replacement seal faces

94.2.6 Remove the rotor retaining ring from the sleeve and re-move the rotor from the sleeve.4.2.7 Remove the O-rings from the sleeve and discard. Be