Flowserve Pac-Seal Type 16 Bedienungsanleitung PDF herunterladen (Seite 4)

1.5 Thoroughly inspect and clean the seal chamber and shaft or pump

sleeve. Inspect for corrosion or any defects. Remove all burrs, cuts,

dents or defects that might damage gaskets or allow a leak path.

Replace worn shaft or pump sleeve

1.6 Check equipment requirements as described in Figure 2. Any

measurement different than what is allowed must be brought within

specications.

1.7 Handle the seal with care; it is manufactured to precise tolerances.

The seal faces are of special importance and should be kept

perfectly clean at all times.

2 Type 16 Installation

2.1 Lubricatetheshaftorsleevelightly.Useawater-basedlubricant

(Pac-Ease recommended). If Pac-Ease is not available use a

solution of liquid dish soap in water as lubricant. Note: Never use

grease or oil as an installation lubricant. Oil used to lubricate the

elastomerbellows/cupgasketwillsignicantlyreducethefriction

drive or anti-rotation capability of the component.

2.2 Lubricatetheouterdiameter(OD)ofthestationaryelastomercup

gasket or O-ring with Pac-Ease.

2.3 Pressthestationarysealseatrmlyintocounterboreensuringitis

bottomed out and squared to the shaft. This can be hand-pressed

or machine-pressed into place taking care to protect the sealing

facefromdirectcontactwithanymetalobject.Useapieceofplastic

between the face and the press or a plastic installation tool when

using a press to install the seat. Additional care must be taken

during the stationary seat assembly to assure the O-ring or cup

gasket is not cut.

1 2 3 4 5 6 7 8

Keine Kommentare

Flowserve Pac-Seal Type 16 Bedienungsanleitung Seite 4