Flowserve Single Inside Pusher Type Seal Bedienungsanleitung Seite 3

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 8
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 2
1.8 Handle all seal parts with care,theyaremanufacturedtoprecise
tolerances.Thesealfaces;rotatingface,andstationaryface,are
ofspecialimportance.Thesetwosealingfacesarelappedatto
withinthreelightbands(34.8millionthsofaninch).
Keep the seal faces perfectly clean at all times.
Single Inside Pusher Type Seal Installation
2 Single End Suction Vertical Split Case Pumps (1 box)
2.1 Scribe mark Aontheshaftorsleevetolineupwiththefaceof
thesealhousing.
2.2 Scribe mark B atthesealsettingpointshownenclosedina
rectangularboxontheassemblydrawingincludedwiththeseal.
Thissealsettingdimensionismeasuredfromthefaceoftheseal
housingtothebackofthespringholder.Thebackofthespring
holderwillbelocatedatthispoint.
2.3 Lubricate the shaftorsleevelightlywithsiliconelubricant
providedwiththesealbeforeinstallinganysealparts.
2.4 Lightly lubricate O-ring or Duraex seat gasket.
2.5 Press the stationary face into the gland (exiblymounted
stationaryfacesonly).Usehandpressureonly.Whereafacehas
anO-ringmountingonthebackshoulder,itisusuallybetterto
nestthisO-ringintotheglandcavityandthenpushthefaceinto
thenestedO-ring.
2.6 Install the glandwithstationaryfaceovertheshaft.Placethe
glandasclosetothebearingbracketaspossible.Donotbump
thestationaryfaceagainsttheshaftasitmaychip,crack,orbreak.
2.7 Installthe rotating face gasketintotheboreoftherotatingface.
2.8 Install the rotating facecomponentsontheshaftorsleevein
thepropersequence.HandlePTFEU-cupringsandDurate
rotatingfacegasketswithextremecare.PTFEU-cupringsmust
beassembledindividuallyandnotpushedontheshaftorsleeve
whiletheyareinstalledontherotatingface.Avoidnickingor
pinchingeitherlipoftheU-cupring.UsebothU-cuprings,they
worktogethertoformaneffectiveseal.
3
Seitenansicht 2
1 2 3 4 5 6 7 8

Kommentare zu diesen Handbüchern

Keine Kommentare