Flowserve PSS III Seal Durametallic Bedienungsanleitung PDF herunterladen

Installation

Instructions

Split Seal

Durametallic

PSS III

Experience In Motion

1 2 3 4 5 6 7 8

Inhaltsverzeichnis

Seite 1 - Instructions

Installation InstructionsSplit SealDurametallic® PSS IIIExperience In Motion

Seite 2 - Figure 2

While the PSS III has been designed for rugged industrial application and ease of installation, it does require assembly in a clean environment accord

Seite 3 - Seal Drive Installation

Tools Needed for Installation • 5/32", 5/16" and 3/32" or 1/8" T-handle hex key wrenches (supplied with seal) • An open end wre

Seite 4 - Gland Installation

Step 4a With the setting devices against the box face, tighten the set screws. All sizes have eight set screws. Tighten all four loc

Seite 5 - 2.5 to 4.8 mm

Step 7 Observe the length of the lock pin outside of the gland. The pin should extend 2.5 to 4.8 mm (0.10 to 0.19 inch) from the gland.

Seite 6 - Operational Recommendations

Notes for Figure 3: • Recommendations are for use in water or other similar viscosity liquids. • These recommendations apply to products having a

Seite 7

RepairsThis product is a precision sealing device. The design and dimension tolerances are critical to seal performance. Only parts supplied by Flowse

Seite 8 - TO REORDER REFER TO

TO REORDER REFER TOB/M #F.O.To ﬁnd your local Flowserve representativeand ﬁnd out more about Flowserve Corporation, visit www.ﬂowserve.comFIS175eng RE