Flowserve URB 1 Bedienungsanleitung PDF herunterladen (Seite 16)

Basic Settings – continued –

Changing factory set node ID of the URB 1 / Adjusting & changing node ID

The factory set node ID of the URB 1 is

“060”. Node IDs below this value are

reserved for other GESTRA bus

components.

If additional operating terminals type URB 1

are used in a CAN bus system, you have to

set their node IDs to values above “060”.

Note that the newly established node IDs

must not be identical with node IDs of other

bus components.

Press and hold button for a few

seconds to enter the address

parameterisation mode.

Press button briefly to activate the

line selection mode.

a few seconds

briefly

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 79 80

Keine Kommentare

Flowserve URB 1 Bedienungsanleitung Seite 16