Flowserve ISC2BB Bedienungsanleitung Seite 1

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Hardware Flowserve ISC2BB herunter. Flowserve ISC2BB User Manual Benutzerhandbuch

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 12
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 0
Repair Instructions
ISC
Flow Solutions Division
ISC2BB
Dual Rotating Bellows Seal
Seitenansicht 0
1 2 3 4 5 6 ... 11 12

Inhaltsverzeichnis

Seite 1 - Repair Instructions

Repair InstructionsISCFlow Solutions DivisionISC2BBDual Rotating Bellows Seal

Seite 2 - 1 Nomenclature

Figure 20104.18 Using firm hand pressurepress down on the collar tobe even with the end of thesleeve assembly. This will inturn press down the glandan

Seite 3 - 2 Disassembly

Figure 21O-ring11Gland GasketG11 2 Trademark of Minnesota Mining and Manufacturing Company5 Static Testing5.1 Flowserve manufacturing typically tests

Seite 4

TO REORDER REFER TOB/M #F.O.FIS139ORG 06/00 USAFlowserve Corporation Flow Solutions DivisionPrinted in U.S.A.ISO 9000CertifiedGermanyBrazilMexicoKalam

Seite 5 - 4 Seal Assembly Instructions

2© Copyright 2000 Flowserve Corporation1 NomenclatureNotes: - Inboard bellows assembly (34A) is interchangeable with outboard bellows assembly (34).-

Seite 6

2 Disassembly33 Inspection and Reconditioning3.2 Gland Assembly 1 (Figure 2)Figure 21 Registered Trademark of Loctite CorporationWhen disassemblin

Seite 7

43.4 Inner Gland 1B (Figure 4)A Dynamic O-ring surface - Inspectfor wear, fretting, nicks, scratches,or corrosion. Required surfacefinish: 32 RMSB

Seite 8

SL on a flat surface with thecollar end facing up. Installthe inboard vibration dampener M1 into the sleeve end housing.Place the inboard bellows O

Seite 9

4.5 Align the two flats on theinboard bellows assembly 34A with the two flats on theinside of the drive ring 10Ain the sleeve end housing,and press

Seite 10 - Centering

74.8 Place the inner gland/matingring assembly face downonto the sleeve/bellowsassembly. (Figure 11)4.9 Install the inner gland O-ring G1 into the fa

Seite 11 - 6 Installation

4.12 Insert the retaining ring RRinto the groove in the sleeveassembly while pressingdown on the rotor carrier.Make sure that the retainingring snaps

Seite 12 - TO REORDER REFER TO

4.15 Align the two flats on themating ring 3B with the twoflats on the inside of thegland drive ring in the glandassembly, and press themating ring

Kommentare zu diesen Handbüchern

Keine Kommentare