Flowserve ISC2SS Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Hardware Flowserve ISC2SS herunter. Flowserve ISC2SS User Manual Benutzerhandbuch

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 12
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 0
Repair Instructions
ISC
Flow Solutions Division
ISC2SS
Dual Stationary Bellows Seal
Seitenansicht 0
1 2 3 4 5 6 ... 11 12

Inhaltsverzeichnis

Seite 1 - Repair Instructions

Repair InstructionsISCFlow Solutions DivisionISC2SSDual Stationary Bellows Seal

Seite 2 - 1 Nomenclature

10 2 Trademark of Minnesota Mining and Manufacturing Company4.17 Using firm hand pressurepress down on the collar tobe even with the end of thesleeve

Seite 3 - 2 Disassembly

Figure 22O-ring11Gland GasketG115 Static Testing5.1 Flowserve manufacturing typically tests the ISC at 25 psig. A pressure dropof less than one psi ov

Seite 4

TO REORDER REFER TOB/M #F.O.FIS141ORG 06/00 USAFlowserve Corporation Flow Solutions DivisionPrinted in U.S.A.ISO 9000CertifiedGermanyBrazilMexicoKalam

Seite 5 - 4 Seal Assembly Instructions

2© Copyright 2000 Flowserve Corporation1 NomenclatureNotes: - Inboard bellows assembly (34A) is interchangeable with outboard bellows assembly (34).-

Seite 6

2 Disassembly33 Inspection and Reconditioning3.2 Gland Assembly 1 (Figure 2)Figure 21 Registered Trademark of Loctite CorporationWhen disassemblin

Seite 7

43.4 Inner Gland 1C (Figure 4)A Mating ring O-ring surface - Inspectfor wear, fretting, nicks, scratches,or corrosion. Required surfacefinish: 63

Seite 8

SL on a flat surface with thecollar end facing up. Installthe inboard vibration dampener M1 into the sleeve end housing.Place the inboard bellows O

Seite 9

4.5 Align the two flats on theinboard mating ring 3C withthe two flats on the inside ofthe drive ring 10A in thesleeve end housing, andpress the m

Seite 10 - 15 degrees. Align this

74.8 Place the inner gland/bellowsassembly face down onto thesleeve/mating ring assembly.(Figure 11)4.9 Install the inner gland O-ring G1 into the fa

Seite 11 - 6 Installation

4.12 Insert the retaining ring RRinto the groove in the sleeveassembly while pressingdown on the rotor carrier.Make sure that the retainingring snaps

Seite 12 - TO REORDER REFER TO

9Figure 174.15 Place the gland/bellowsassembly face down onto thesleeve/outboard mating ringassembly. (Figure 19)Figure 184.15 Assemble the outboardbe

Kommentare zu diesen Handbüchern

Keine Kommentare